Livorsi DTS Controls Manuel d'utilisateur télécharger pdf (Page 4)

Livorsi DTS Controls- Three/Four Engine Installation APRIL 2012 Page 4 of 9

Livorsi DTS Control Dimension Chart

Number of Handles “A” DIM “B” DIM

3 handle 4- 1/2 in. 4- 1/64 in.

4 handle 5- 11/16 in. 5- 3/16 in.

6 handle 8 in. 7- 1/2 in.

8 handle 10- 5/16 in. 9- 13/16 in.

Installing the Control

Control Configuration

Important: Canting refers to the direction of bend in handle. Install the Livorsi DTS

Controls in the orientation specified for that model (aft-cant port, forward-cant port,

aft-cant starboard, or forward-cant starboard)

Cutting the Control Console Opening

1. Remove the Console Cutout page, located at the end of this document.

Important:

Hole patterns between the DTS flat base and DTS contour base

differ.

2. Transfer all drill holes and cut lines to the console in a suitable location. Refer to

Dimensions and Clearances for help determining the installation location.

Important: Ensure that the area below the console is clear of any wiring or items that

may hinder or be damaged by drilling/cutting.

a- Forward cant models

b- Aft cant models

c- Arrow pointing to the ship’s bow

1 2 3 4 5 6 7 8 9 ... 18 19

Pas de commentaire

Livorsi DTS Controls Manuel d'utilisateur Page 4